Mark Levinson No.52 Preamp


Used Prices  US$ 11000

Mark Levinson No.52 Dual-Monaural Preamplifier With Seven Analog Inputs

Comes with (power supply part), (control box part), Power cable, 2 DC power cables, control cable,
Remote control, Phillips screwdriver, instruction manual, user’s guide, original box.

The operation has been confirmed.
There was no problem with each input / output, LCD, and lamps.

* The internal settings of this unit have been restored to the factory settings.

The exterior has one small dent on the remote control,
Other than that, I didn’t feel any noticeable scratches or usability.
It is in a very beautiful state.

Two-piece chassis with separate control box and analog box
Dual Monaural construction and signal paths/routing
AC regeneration circuitry
7 Analog inputs: 3 XLR and 4 RCA stereo input pairs
Phono input with support for both MM and MC cartridges
Rear-panel USB (A) connector for software updates

Design: Stereo (Dual Mono) Preamplifier
Maximum Output Voltage: 16 Volts RMS XLR, 8 Volts RMS RCA Coax
MFR: 10 Hz – 40 kHz ± 0.2 dB
Volume Control Range: 80 dB
Line Stage Gain: 0 dB, +6 dB, +12 dB, +18 dB (Selectable)
Phono Stage Gain: +40 dB, +60 dB (Selectable)
Main Volume Control Gain Resolution: 1 dB up to 23 dB, 0.1 dB from 23 dB to 80 dB
Inputs: 3 x XLR, 4 x RCA, 1 x RCA Phono, 1 x USB-1 for Firmware Updates
Outputs: 1 x XLR, 1 x RCA, 1 x RCA Record Loop
Input Impedance: 100 kOhms
Output Impedance: 20 Ohms XLR, 10 Ohms RCA
SNR: 120 dB, 20 Hz – 20 kHz
Dimensions: 8.75″ H (both chassis together) x 17.25″ W x 13″ D
Weight: 60 Pounds Total


There are no reviews yet.

Be the first to review “Mark Levinson No.52 Preamp”

Your email address will not be published. Required fields are marked *